Email: info@falgateaggregates.co.ukEmail usPhone: 07450 701529Call usMonday – Friday 08:00–17:00Order before 1pm for next-day delivery

How much aggregate do I need?

Work out how much gravel, sub-base or sand you need: measure the area, choose a depth, convert to cubic metres and tonnes, and decide between loose bulk and bulk bags.

Measure the area

Measure the length and width of the area in metres. For an L-shaped or irregular area, split it into rectangles, work out each one and add them together. For a circle, multiply 3.14 by the radius squared.

Choose the depth

The depth depends on the material and the job. As a guide:

  • Decorative gravel and chippings: 40–50mm for paths and borders, and around 50mm for driveways.
  • Type 1 sub-base: around 100mm compacted for patios and paths, and 150mm or more for driveways, depending on ground conditions.
  • Capping and bulk fill such as 6F2 and 6F5: set by your design or engineer.

If your job has a written specification, use the depths it gives.

Work out the volume

Multiply length × width × depth, with the depth in metres (50mm = 0.05m, 100mm = 0.1m). The answer is in cubic metres (m³).

Example: a 5m × 4m border at 50mm deep is 5 × 4 × 0.05 = 1m³.

Convert to tonnes

Aggregates are sold by weight, so multiply the volume by the material’s bulk density (tonnes per m³). Density varies between materials, sources, gradings and moisture levels, so treat any figure as a planning estimate.

Example: at 1.6 tonnes per m³, the 1m³ border above needs about 1.6 tonnes.

For compacted materials such as Type 1, measure the finished compacted depth and allow extra for compaction. Ask us if you are unsure how much to allow.

Our tonnage calculator does these steps for you, using a typical density for each material.

Loose bulk or bulk bags?

Bulk bags suit smaller jobs and drives where you want the material contained in one place. Loose bulk is tipped straight from the lorry and is usually the better choice for larger quantities. The calculator shows the equivalent number of bulk bags for your estimate.

If the material needs to go over a wall or fence, or into an area a tipper cannot reach, ask about grab hire.

Topping up an existing area

Natural stone varies in colour from load to load. If you are topping up existing gravel, tell us when you enquire so we can talk through how closely the current supply matches.

Frequently asked questions

How many tonnes of gravel do I need for a driveway?

Multiply length × width × depth to get cubic metres, then multiply by the density. A 10m × 3m driveway with 50mm of gravel is 1.5m³, which is about 2.4 tonnes at 1.6 tonnes per m³. The sub-base underneath is calculated separately.

Should I measure the depth before or after compaction?

Use the finished, compacted depth for sub-base materials, then allow extra for compaction. Decorative gravel is not compacted, so use the depth you want to see.

Is the calculator result exact?

No. It is a planning estimate based on a typical density. The actual weight varies with the source, grading, moisture and compaction, so confirm your final quantity with us before ordering.

Need a quote?

Tell us the material, quantity and delivery postcode, or call 07450 701529, Monday–Friday 08:00–17:00.

Our Accreditation

FORS Bronze — Fleet Operator Recognition Scheme